How to complete initial setup by using the wizard (password, date & time, etc)

The next step is going to be going through the Startup Wizard and getting the basics configured. You can watch the video on the right that will show you how to navigate the Wizard.

1

Create a personalized, secure password.

2

Set the proper timezone, verify date & time is correct, and set the date & time format to your preference.

3

Network configuration. Your NVR should have a static IP address on your local network. If you’re unfamiliar with IP addressing leave it set for “Obtain an IP address automatically” and continue the Wizard. Also make sure to change the HTTP port to something other than 80, we generally use 88.

4

Skip the QR code scan & the Add Camera pages

5

Make sure you check the status of your disk in this page.

6

Decide how you would like your cameras to record