Register
Log In
Home
Add Reply
Add Topic
October 1, 2016
Offline
Hi,
I am setting up a tridvr-ele8me recorder for the first time, I am adding a Sibell IP camera. I see the camera as well as my other analog cameras and the analog cameras are recording. But I cannot get the Sibell camera to Motion Detect record, also I cannot change it's name.
On the video detection menu, when I select channel 4 for that camera I have been seeing a warning popping up that "channel 4 fail to get configuration".
Any Ideas are much appreciated.
Gary
See AnswerOctober 1, 2016
Offline
Found This on another Thread. Ok about the config but how can I get it to record on my TRIDVR and will the cameras motion detect work.
My current issue is with the motion detect. When I try and set motion detect region, I get the error:
Channel 1 failed to get configuration
And on the 'Motion Detect' tab of the menu, there is no widget for setting sensitivity.
When I subsequently try to modify the motion detect area and say 'OK', I get:
Failed to save the configuration information
I tried doing a hard reset on the camera itself; restarting the NVR; and like I said, wound up moving the camera to another port.
I don't know if it's relevant, but when I select 'Modify' the camera in the added device list, and then try to connect to the camera (admin/admin), nothing happens.
Answers Post
1 Guest(s)
