April 9, 2013
![sp_UserOfflineSmall](https://www.securitycameraking.com/securityinfo/wp-content/sp-resources/forum-themes/reboot/images/darkpack/sp_UserOfflineSmall.png)
Is there a way I can get into camera setup mode for this camera? Am I wrong on thinking that it's usually accessed via the Preset #/PTZ area? If so, what preset number do I use? Nothing in the manual showing anything about getting into the setup for this camera. Wondering if I can configure this camera for digital zoom. Thanks.
IPPTZ-EL2MPIR250L30X-D2 (Preset Number For Config setting)
![Avatar](https://www.securitycameraking.com/securityinfo/wp-content/sp-resources/forum-avatars/defaults/guestdefault.png)
An IP PTZ should be plugged into your main network, and you should be able to access the IP address with the web service. Smart PSS is not a good choice for any configuration, and may have limited abilities. The best tool for the job is the web service of the camera. If you are plugging a PTZ into a built in POE switch of an NVR, that is a BIG NO NO. The PTZ should get power from it's own power supply.
1 Guest(s)
![sp_Information](https://www.securitycameraking.com/securityinfo/wp-content/sp-resources/forum-themes/reboot/images/darkpack/sp_Information.png)